Limit Curve

• Command_Manual
  • Tcl Commands
  • Modeling_Commands
    • model
    • uniaxialMaterial
    • ndMaterial
    • frictionModel
    • section
    • geometricTransf
    • element
    • node
    • sp commands
      • fix
      • fixX
      • fixY
      • fixZ
    • mp commands
      • equalDOF
      • rigidDiaphragm
      • rigidLink
    • timeSeries
    • pattern
    • mass
    • block commands
      • block2D
      • block3D
    • region
    • rayleigh
  • Analysis Commands
    • constraints Command
    • numberer Command
    • system Command
    • test Command
    • algorithm Command
    • integrator Command
    • analysis Command
    • eigen Command
    • analyze Command
  • Output Commands
    • recorder
    • record
    • print
    • printA
    • logFile
    • RealTime_Output_Commands
  • Misc Commands
    • eleResponse Command
    • getTime Command
    • getEleTags Command
    • getNodeTags
    • loadConst Command
    • nodeCoord Command
    • nodeDisp Command
    • nodeVel Command
    • nodeAccel Command
    • nodeEigenvector Command
    • nodeBounds
    • print Command
    • remove Command
    • reset Command
    • testIter
    • testNorms
    • wipe Command
    • exit Command
  • DataBase Commands
    • Template:DataBaseCommandsMenu

---

This command is used to construct a failure curve for a limit state material.

limitCurve $type $arg1 $arg2 ...

---

$type	type of limit curve
$arg1 $arg2 ..	args depending on $type

The following contain information about the valid types and the args required for each:

• Steel & Reinforcing-Steel Materials
  • Shear LimitCurve
  • Axial LimitCurve

---

EXAMPLE:

LimitStateMaterialExample

---

DESCRIPTION:

Modeling Failures in Existing Reinforced Concrete Columns by Ken Elwood: File:ElwoodCJCE2004.pdf

---

REFERENCES:

Elwood, K.J and Moehle, J.P., "Shake Table Tests and Analystical Studies on the Gravity Load Collapse of Reinforced Concrete Frames", Pacific Earthquake Engineering Research Center, University of California, Berkeley, CA. PEER 2003/01.

---

Code Developed by: Ken Elwood, University of British Columbia