Analysis Commands
Jump to navigation
Jump to search
- Command_Manual
- Tcl Commands
- Modeling_Commands
- model
- uniaxialMaterial
- ndMaterial
- frictionModel
- section
- geometricTransf
- element
- node
- sp commands
- mp commands
- timeSeries
- pattern
- mass
- block commands
- region
- rayleigh
- Analysis Commands
- Output Commands
- Misc Commands
- DataBase Commands
In OpenSees, an analysis is an object which is composed by the aggregation of component objects. It is the component objects which define the type of analysis that is performed on the model. The component classes, as shown in the figure below, consist of the following:
- ConstraintHandler -- determines how the constraint equations are enforced in the analysis -- how it handles the boundary conditions/imposed displacements
- DOF_Numberer -- determines the mapping between equation numbers and degrees-of-freedom
- Integrator -- determines the predictive step for time t+dt
- SolutionAlgorithm -- determines the sequence of steps taken to solve the non-linear equation at the current time step
- SystemOfEqn/Solver -- within the solution algorithm, it specifies how to store and solve the system of equations in the analysis
- Convergence Test -- determines when convergence has been achieved.
<uml> package "OpenSees Analysis" #DDDDDD
abstract class Integrator abstract class Analysis abstract class SystemOfEqn abstract Class ConvergenceTest abstract class Algorithm Analysis o- ConstraintHandler Analysis o- Numberer Analysis o- Algorithm Analysis o- ConvergenceTest Analysis o- Integrator Analysis o- SystemOfEqn </uml>
The following Analysis commands are added to the interpreter to create the Analysis and perform the analysis: