Tri31 Element

From OpenSeesWiki
Revision as of 06:21, 6 April 2016 by Roozbehg (talk | contribs)
Jump to navigation Jump to search




This command is used to construct a constant strain triangular element (Tri31) which uses three nodes and one integration points.

element tri31 $eleTag $iNode $jNode $kNode $thick $type $matTag <$pressure $rho $b1 $b2>


$eleTag unique element object tag
$iNode $jNode $kNode three nodes defining element boundaries, input in counter-clockwise order around the element.
$thick element thickness
$type string representing material behavior. The type parameter can be either "PlaneStrain" or "PlaneStress."
$matTag tag of nDMaterial
$pressure surface pressure (optional, default = 0.0)
$rho element mass density (per unit volume) from which a lumped element mass matrix is computed (optional, default=0.0)
$b1 z$b2 constant body forces defined in the domain (optional, default=0.0)


NOTE:

  1. Consistent nodal loads are computed from the pressure and body forces.
  2. The valid queries to a Tri31 element when creating an ElementRecorder object are 'forces', 'stresses,' and 'material $matNum matArg1 matArg2 ...' Where $matNum refers to the material object at the integration point corresponding to the node numbers in the domain.

Code Developed by: Roozbeh G. Mikola, UC Berkeley and N. Sitar, UC Berkeley