ConcreteD

From OpenSeesWiki
Revision as of 22:42, 27 May 2015 by Fmk (talk | contribs)
Jump to navigation Jump to search




This command is used to construct a concrete material based on the Chinese design code.

uniaxialMaterial ConcreteD $matTag $fc $epsc $ft $epst $Ec $alphac $alphat <$cesp> <$etap>

$matTag integer tag identifying material
$fc concrete compressive strength *
$epsc concrete strain at corresponding to compressive strength*
$ft concrete tensile strength *
$epst concrete strain at corresponding to tensile strength*
$Ec concrete initial Elastic modulus*
$alphac compressive descending parameter*
$alphat tensile descending parameter*
$cesp plastic parameter, recommended values: 0.2~0.3*
$etap plastic parameter, recommended values: 1.0~1.3*

NOTE: 1. Concrete compressive strength and the corresponding strain should be input as negative values. 2. The value $fc/$epsc and $ft/$epst should be smaller than $Ec. 3. The default value for $cesp and $etap are 0.25 and 1.15, respectively.

EXAMPLE: Example 1: Simulation of compressive test in Karson and Jirsa (1969).

uniaxialMaterial ConcreteD 1 -27.6 -0.002 3 0.0001 35000 1.0 0.1 0.25 1.15

REFERENCES: Reference

[1] Karsan, I. D., and Jirsa, J. O. (1969). “Behavior of concrete under compressive loadings.” Journal of the Structural Division, 95(12), 2535-2563.

[2] Ministry of Housing and Urban-Rural Development of the People’s Republic of China. (2010). “Code for design of concrete structures.” GB50010-2010, Beijing, China.

[3] Ren, X. D. (2010). Multi-scale based stochastic damage constitutive theory for concrete. Doctoral dissertation, Tongji University, Shanghai. (in Chinese)

[4] Wu, J. Y., Li, J., and Faria, R. (2006). “An energy release rate-based plastic-damage model for concrete.” International Journal of Solids and Structures, 43(3), 583-612.

[5] Zeng, S. J. (2012). Dynamic Experimental Research and Stochastic Damage Constitutive Model for Concrete. Doctoral dissertation, Tongji University, Shanghai. (in Chinese)