KikuchiAikenHDR Material

• Command_Manual
  • Tcl Commands
  • Modeling_Commands
    • model
    • uniaxialMaterial
    • ndMaterial
    • frictionModel
    • section
    • geometricTransf
    • element
    • node
    • sp commands
      • fix
      • fixX
      • fixY
      • fixZ
    • mp commands
      • equalDOF
      • rigidDiaphragm
      • rigidLink
    • timeSeries
    • pattern
    • mass
    • block commands
      • block2D
      • block3D
    • region
    • rayleigh
  • Analysis Commands
    • constraints Command
    • numberer Command
    • system Command
    • test Command
    • algorithm Command
    • integrator Command
    • analysis Command
    • eigen Command
    • analyze Command
  • Output Commands
    • recorder
    • record
    • print
    • printA
    • logFile
    • RealTime_Output_Commands
  • Misc Commands
    • eleResponse Command
    • getTime Command
    • getEleTags Command
    • getNodeTags
    • loadConst Command
    • nodeCoord Command
    • nodeDisp Command
    • nodeVel Command
    • nodeAccel Command
    • nodeEigenvector Command
    • nodeBounds
    • print Command
    • remove Command
    • reset Command
    • testIter
    • testNorms
    • wipe Command
    • exit Command
  • DataBase Commands
    • Template:DataBaseCommandsMenu

---

This command is used to construct a uniaxial KikuchiAikenHDR material object. This material model produces nonlinear hysteretic curves of high damping rubber bearings (HDRs).

uniaxialMaterial KikuchiAikenHDR $matTag $tp $ar $hr <-coGHU $cg $ch $cu> <-coMSS $rs $rf>

---

$matTag	integer tag identifying material
$tp	rubber type (see note 1)
$ar	area of rubber [unit: m^2] (see note 2)
$hr	total thickness of rubber [unit: m] (see note 2)
$cg $ch $cu	correction coefficients for equivalent shear modulus ($cg), equivalent viscous daming ratio ($ch), ratio of shear force at zero displacement ($cu).
$rs $rf	reduction rate for stiffness ($rs) and force ($rf) (see note 3)

NOTES:

1) Following rubber types for $tp are available:

X0.6	Bridgestone X0.6, standard compressive stress
X0.6-0MPa	Bridgestone X0.6, zero compressive stress

2) This material uses SI unit in calculation formula. $ar and $hr must be converted into [m^2] and [m], respectively.

3) $rs and $rf are　available if this material is applied to multipleShearSpring (MSS) element. Recommended values are $rs=1/sum(i=0,n-1){ sin(n*i/pi)^2} and $rf=1/sum(i=0,n-1){sin(n*i/pi)}, where n is the number of springs in the MSS. For example, when n=8, $rs=0.2500, $rf=0.1989.

---

EXAMPLE:

KikuchiAikenHDR_sample.tcl

---

Code Developed by: mkiku