RigidDiaphragm command

• Command_Manual
  • Tcl Commands
  • Modeling_Commands
    • model
    • uniaxialMaterial
    • ndMaterial
    • frictionModel
    • section
    • geometricTransf
    • element
    • node
    • sp commands
      • fix
      • fixX
      • fixY
      • fixZ
    • mp commands
      • equalDOF
      • rigidDiaphragm
      • rigidLink
    • timeSeries
    • pattern
    • mass
    • block commands
      • block2D
      • block3D
    • region
    • rayleigh
  • Analysis Commands
    • constraints Command
    • numberer Command
    • system Command
    • test Command
    • algorithm Command
    • integrator Command
    • analysis Command
    • eigen Command
    • analyze Command
  • Output Commands
    • recorder
    • record
    • print
    • printA
    • logFile
    • RealTime_Output_Commands
  • Misc Commands
    • eleResponse Command
    • getTime Command
    • getEleTags Command
    • getNodeTags
    • loadConst Command
    • nodeCoord Command
    • nodeDisp Command
    • nodeVel Command
    • nodeAccel Command
    • nodeEigenvector Command
    • nodeBounds
    • print Command
    • remove Command
    • reset Command
    • testIter
    • testNorms
    • wipe Command
    • exit Command
  • DataBase Commands
    • Template:DataBaseCommandsMenu

---

This command is used to construct a number of Multi-Point Constraint (MP_Constraint) objects. These objects will constraint certain degrees-of-freedom at the listed slave nodes to move as if in a rigid plane with the master node.

rigidDiaphragm $perpDirn $masterNodeTag $slaveNodeTag1 $slaveNodeTag2 ...

---

$perpDirn	direction perpendicular to the rigid plane (i.e. direction 3 corresponds to the 1-2 plane)
$masterNodeTag	integer tag identifying the master node
$slaveNodeTag1 $slaveNodeTag2 ...	integar tags identifying the slave nodes

NOTE: The constraint object is constructed assuming small rotations.

NOTE: The rigidDiaphragm command works only for problems in three dimensions with six-degrees-of-freedom at the nodes (ndf = 6).

EXAMPLE:

rigidDiaphragm 2 2 4 5 6; constrain nodes 4,5,6 to move as if in the same x-z plane as node 2.

Code Developed by: fmk