Transformation Method
- Command_Manual
- Tcl Commands
- Modeling_Commands
- model
- uniaxialMaterial
- ndMaterial
- frictionModel
- section
- geometricTransf
- element
- node
- sp commands
- mp commands
- timeSeries
- pattern
- mass
- block commands
- region
- rayleigh
- Analysis Commands
- Output Commands
- Misc Commands
- DataBase Commands
This command is used to construct a transformation constraint handler, which enforces the constraints using the transformation method. The following is the command to construct a transformation constraint handler:
constraints Transformation |
NOTES:
- The single-point constraints when using the transformation method are done directly. The matrix equation is not manipulated to enforce them, rather the trial displacements are set directly at the nodes at the start of each analysis step.
THEORY:
Code Developed by: fmk