DoddRestrepo: Difference between revisions

From OpenSeesWiki
Jump to navigation Jump to search
No edit summary
No edit summary
Line 28: Line 28:
|  '''$OmegaFac''' || Bauschinger curve roundness factor. Range: [0.75, 1.15].  Largest value tends to near a bilinear Bauschinger curve.  Default = 1.0.
|  '''$OmegaFac''' || Bauschinger curve roundness factor. Range: [0.75, 1.15].  Largest value tends to near a bilinear Bauschinger curve.  Default = 1.0.
|-
|-
Note:  Stresses and strains are defined engineering terms, as they are reported in a tensile test
|}
|}



Revision as of 03:03, 6 November 2011




This command is used to construct a Dodd-Restrepo steel material

uniaxialMaterial Dodd_Restrepo $tag $Fy $Fsu $ESH $ESU $Youngs $ESHI $FSHI <$OmegaFac>

Note: Stresses and strains are defined engineering terms, as they are reported in a tensile test
$matTag Integer tag identifying material
$Fy Yield strength
$Fsu Ultimate tensile strength (UTS)
$ESH Tensile strain at initiation of strain hardening
$ESU Tensile strain at the UTS
$Youngs Modulus of elasticity
$ESHI Tensile strain for a point on strain hardening curve, recommended range of values for ESHI: [ (ESU + 5*ESH)/6, (ESU + 3*ESH)/4]
$FSHI Tensile stress at point on strain hardening curve corresponding to ESHI
$OmegaFac Bauschinger curve roundness factor. Range: [0.75, 1.15]. Largest value tends to near a bilinear Bauschinger curve. Default = 1.0.

Examples:


References:

Code Developed by : L.L. Dodd & J. Restrepo