Load Control: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 12: | Line 12: | ||
| style="width:150px" | '''$lambda ''' || <math>\lambda</math> factor | | style="width:150px" | '''$lambda ''' || <math>\lambda</math> factor | ||
|- | |- | ||
| $numIter || the number of iterations the user would like to occur in the solution algorithm. Optional, default = 1.0. | | '''$numIter''' || the number of iterations the user would like to occur in the solution algorithm. Optional, default = 1.0. | ||
|- | |- | ||
| $minLambda || the min stepsize the user will allow. optional, defualt = <math>\lambda_{min} = \lambda</math> | | '''$minLambda''' || the min stepsize the user will allow. optional, defualt = <math>\lambda_{min} = \lambda</math> | ||
|- | |- | ||
| $maxLambda || the max stepsize the user will allow. optional, default = <math>\lambda_{max} = \lambda</math> | | '''$maxLambda''' || the max stepsize the user will allow. optional, default = <math>\lambda_{max} = \lambda</math> | ||
|} | |} | ||
Revision as of 00:53, 31 August 2010
- Command_Manual
- Tcl Commands
- Modeling_Commands
- model
- uniaxialMaterial
- ndMaterial
- frictionModel
- section
- geometricTransf
- element
- node
- sp commands
- mp commands
- timeSeries
- pattern
- mass
- block commands
- region
- rayleigh
- Analysis Commands
- Output Commands
- Misc Commands
- DataBase Commands
This command is used to construct a LoadControl integrator object.
| integrator LoadControl $lambda <$numIter $minLambda $maxLambda> |
| $lambda | <math>\lambda</math> factor |
| $numIter | the number of iterations the user would like to occur in the solution algorithm. Optional, default = 1.0. |
| $minLambda | the min stepsize the user will allow. optional, defualt = <math>\lambda_{min} = \lambda</math> |
| $maxLambda | the max stepsize the user will allow. optional, default = <math>\lambda_{max} = \lambda</math> |
NOTES:
- The change in applied loads that this causes depends on the active load patterns (those load patterns not set constant) and the loads in the load patterns. If the only active loads acting on the domain are in load patterns with a Linear time series with a factor of 1.0, this integrator is the same as the classical load control method.
- The optional arguments are supplied to speed up the step size in cases where convergence is too fast and slow down the step size in cases where convergence is too slow.
EXAMPLE:
integrator LoadControl 0.1;
THEORY:
In Load Control the time in the domain is set to <math>t + \lambda_{t+1}</math> where,
- <math> \lambda_{t+1} = \max \left ( \lambda_{min}, \min \left ( \lambda_{max}, \frac{\text{numIter}}{\text{lastNumIter}} \lambda_{t} \right ) \right ) </math>
Code Developed by: fmk