ZeroLengthImpact3D: Difference between revisions

Revision as of 18:29, 28 May 2013

This command constructs a node-to-node zero-length contact element in 3D space.

element zeroLengthImpact3D $tag $slaveNode $masterNode $direction $initGap $frictionRatio $Kt $Kn $Kn2 $Delta_y $cohesion

$tag	unique element object tag
$slaveNode	Slave node tag
$masterNode	Master node tag
$direction	1 if normal vector of master plane points to +X direction 2 if normal vector of master plane points to +Y direction 3 if normal vector of master plane points to +Z direction
$initGap	Initial gap between master plane and slave plane
$frictionRatio	Friction ratio
$Kt	Penalty in tangential directions (parallel to master and slave planes)
$Kn	Penalty in normal direction (normal to master and slave planes)
$Kn2	Penalty in normal direction after yielding based on Hertz impact model
$Delta_y	Yield deformation based on Hertz impact model
$cohesion	Cohesion, if no cohesion, it is zero

NOTES:

This element has been developed on top of the “zeroLengthContact3D” element “ImpactMaterial”. All the notes available in the following link would apply to the new element as well. This includes the definition of master and slave nodes, the number of degrees of freedom in the domain, etc.

EXAMPLES:

Gang Wang to provide a smart example!

REFERENCES:

Code Developed by: Arash E. Zaghi, Majid Cashany, University of Connecticut (UConn)

@@ Line 46: / Line 46: @@
 NOTES:
-# This element has been developed on top of the “zeroLengthContact3D” element ImpactMaterial. All the notes available in the following link would apply to the new element as well. This includes the definition of master and slave nodes, the number of degrees of freedom in the domain, etc.
+# This element has been developed on top of the “zeroLengthContact3D” element “ImpactMaterial”. All the notes available in the following link would apply to the new element as well. This includes the definition of master and slave nodes, the number of degrees of freedom in the domain, etc.
 #
 #