FrictionModel Command: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
Line 1: | Line 1: | ||
{{CommandManualMenu}} | {{CommandManualMenu}} | ||
The frictionModel command is used to construct a friction model object, which specifies the behavior of the coefficient of friction in terms of the absolute sliding velocity and the pressure | The frictionModel command is used to construct a friction model object, which specifies the behavior of the coefficient of friction in terms of the absolute sliding velocity and the pressure in the contact area. The command has at least one argument, the friction model type. Each type is outlined below. | ||
Revision as of 01:02, 17 March 2010
- Command_Manual
- Tcl Commands
- Modeling_Commands
- model
- uniaxialMaterial
- ndMaterial
- frictionModel
- section
- geometricTransf
- element
- node
- sp commands
- mp commands
- timeSeries
- pattern
- mass
- block commands
- region
- rayleigh
- Analysis Commands
- Output Commands
- Misc Commands
- DataBase Commands
The frictionModel command is used to construct a friction model object, which specifies the behavior of the coefficient of friction in terms of the absolute sliding velocity and the pressure in the contact area. The command has at least one argument, the friction model type. Each type is outlined below.
frictionModel frnMdlType? arg1? ... |
The type of friction model created and the additional arguments required depend on the frnMdlType? provided in the command.
The following contain information about frnMdlType? and the args required for each of the available friction model types: