Reset Command: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 10: | Line 10: | ||
NOTE: | NOTE: | ||
It iterates over all components of the domain telling them to set their state back to the initial state. This is not always the same as going back to the state of the model after initial model | It iterates over all components of the domain telling them to set their state back to the initial state. This is not always the same as going back to the state of the model after initial model generation, e.g. if elements have been removed. | ||
---- | ---- | ||
Code Developed by: <span style="color:blue"> fmk </span> | Code Developed by: <span style="color:blue"> fmk </span> | ||
Latest revision as of 19:42, 11 February 2011
- Command_Manual
- Tcl Commands
- Modeling_Commands
- model
- uniaxialMaterial
- ndMaterial
- frictionModel
- section
- geometricTransf
- element
- node
- sp commands
- mp commands
- timeSeries
- pattern
- mass
- block commands
- region
- rayleigh
- Analysis Commands
- Output Commands
- Misc Commands
- DataBase Commands
This command is used to set the state of the domain to its original state.
| reset |
NOTE:
It iterates over all components of the domain telling them to set their state back to the initial state. This is not always the same as going back to the state of the model after initial model generation, e.g. if elements have been removed.
Code Developed by: fmk