Getting Started with OpenSees -- Recorders: Difference between revisions
(Created page with 'The OpenSees recorder command is used to define the analysis output. The node recorder will be used to output the horizontal and vertical displacements at node 3 into a file…') |
No edit summary |
||
| (2 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
The OpenSees [[recorder | {{GettingStartedManualMenu}} | ||
The OpenSees [[recorder Command]] is used to define the analysis output. | |||
The node recorder will be used to output the horizontal and vertical displacements at node 3 into a file named Node3.out: | The node recorder will be used to output the horizontal and vertical displacements at node 3 into a file named Node3.out: | ||
| Line 19: | Line 21: | ||
recorder Element -file Element1.out -time -ele 1 force | recorder Element -file Element1.out -time -ele 1 force | ||
</source> | </source> | ||
NOTE: To write the data in the output files a user needs to either exit OpenSees.exe or to issue "wipe" command at the end of the code. | |||
Latest revision as of 18:26, 22 March 2012
- GettingStarted Manual
- Introduction
- Download OpenSees
- Run OpenSees
- Problem Definition
- Model Builder
- Nodes
- Elements
- Recorders
- Summary of Model-Building Input File
- Loads and Analysis
- Gravity Loads
- Summary of Gravity Loads
- Lateral Loads -- Static Pushover
- Lateral Loads -- Cyclic Lateral Load
- Lateral Loads -- Dynamic ground motion
The OpenSees recorder Command is used to define the analysis output.
The node recorder will be used to output the horizontal and vertical displacements at node 3 into a file named Node3.out:
recorder Node <-file $fileName> <-time> <-node ($node1 $node2 ...)> <-nodeRange $startNode $endNode> <-region $RegionTag> <-node all> -dof ($dof1 $dof2 ...) $respType
recorder Node -file Node3.out -time -node 3 -dof 1 2 disp
The element recorder will be used to output the element forces. Element forces for element 1 will be output into file Element1.out:
recorder Element <-file $fileName> <-time> <-ele ($ele1 $ele2 ...)> <-eleRange $startEle $endEle> <-region $regTag> <-ele all> ($arg1 $arg2 ...)
recorder Element -file Element1.out -time -ele 1 force
NOTE: To write the data in the output files a user needs to either exit OpenSees.exe or to issue "wipe" command at the end of the code.
Return to Getting Started with OpenSees