-INFO command line argument

Forum for OpenSees users to post questions, comments, etc. on the use of the OpenSees interpreter, OpenSees.exe

Moderators: silvia, selimgunay, Moderators

Post Reply
divamva
Posts: 27
Joined: Wed Jun 30, 2004 6:52 am
Location: National Technical University of Athens

-INFO command line argument

Post by divamva »

It seems that the -INFO command line argument has been abandoned in the newer versions of OpenSEES. Has it been replaced by another mechanism, or are there any ideas to bring it back? It was mighty useful.
Top
fmk
Site Admin
Posts: 5884
Joined: Fri Jun 11, 2004 2:33 pm
Location: UC Berkeley
Contact:
Contact fmk

Post by fmk »

try putting a quit at the end of the current 2.0.0 exe .. it will default to adding a quit again in next .exe

here is an unofficial version of the .exe

http://opensees.berkeley.edu/OpenSees/c ... .1.exe.zip

this does require tcl8.5 be installed, which may or may not be needed for the next release
Top
Post Reply

Return to “OpenSees.exe Users”