Large Model

This forum is for issues related to parallel processing
and OpenSees using the new interpreters OpenSeesSP and OpenSeesMP

Moderator: selimgunay

Post Reply
brag006
Posts: 173
Joined: Wed Feb 15, 2012 1:26 pm
Location: University of Auckland

Large Model

Post by brag006 »

Hi Everyone,

I have a relatively large model that is taking approximately 12 days to run on a cluster. Unfortunately I'm not actually utlising the full capabilities of the cluster because I don't know how to run this large model using multiple processors.

Basically I successfully use OpenSeesMP for running parametric studies, but I want to run one long EQ motion for one model. I don't know how to speed up that process so that each analysis step is being done faster.

I've tried using OpenSeesSP but that is giving me all kinds of errors. I don't know if it's because of the way it was compiled on the cluster or due to some other reason.

So again I'm looking at ways of improving the speed at which each step is completed.

Any guidance would be much much appreciated.
fmk
Site Admin
Posts: 5884
Joined: Fri Jun 11, 2004 2:33 pm
Location: UC Berkeley
Contact:

Re: Large Model

Post by fmk »

do you compile parallel with MUMPS options? .. how large is the model? and what are errors with SP??
Post Reply