zero-length component in Beamwithhinges element

Forum for OpenSees users to post questions, comments, etc. on the use of the OpenSees interpreter, OpenSees.exe

Moderators: silvia, selimgunay, Moderators

Post Reply
caosasa
Posts: 26
Joined: Sat Aug 07, 2010 5:31 am
Location: tongji

zero-length component in Beamwithhinges element

Post by caosasa »

Dear Vesna and other openseesers:
i have 2 questions about the BWH element,
1. if the length of the elastic part or a hinge part at one end of the BWH element is set to be 0,
will the BWH element work still well?
2. in the model of a long pier in bridge, if several BWH elements is defined,
ie, the length of the three parts of the first BWH element is 1m, 1m, 0.5m from node 1 to node 2.
the length of the three parts of the second BWH element is 0.5m, 1m, 0.5m from node 2 to node 3.
How can the plastic hinge rotation of the plastic hinges at node 2 be computed? can it be computed
as the doubled values of the rotation of plastic hinge part nearby node 2 in element 1?
Thanks a lot.
vesna
Posts: 3033
Joined: Tue May 23, 2006 11:23 am
Location: UC Berkeley

Re: zero-length component in Beamwithhinges element

Post by vesna »

1. I don't think so. However, I suggest you to test it.

2. I would not use 3 BWH elements to model one pier. This element is intended to be used to model only one structural element with plastic hinges located at its ends.
caosasa
Posts: 26
Joined: Sat Aug 07, 2010 5:31 am
Location: tongji

Re: zero-length component in Beamwithhinges element

Post by caosasa »

Thank you Vesna.
I see.
Post Reply