The DamageModel command can not be used in OpenSEES .
There may be some error in the source codes TclModelBuilderDamageModelCommand.cpp.
I'd like to know when the DamageModel command would be available. thank you.
Damage Model can not be used in OpenSEES 2.3.1
Moderators: silvia, selimgunay, Moderators
Re: Damage Model can not be used in OpenSEES 2.3.1
yeah, I am reading this part too.
from warning, the value in setResponse is zero, and the program exit when sourcing.
from warning, the value in setResponse is zero, and the program exit when sourcing.
Kai Zhang
------------------------------
PH.D. candidate
School of Civil Engineering&Architecture
Beijing Jiaotong University
------------------------------
PH.D. candidate
School of Civil Engineering&Architecture
Beijing Jiaotong University
-
wuhaoshrek
- Posts: 122
- Joined: Tue Oct 28, 2008 4:01 am
Re: Damage Model can not be used in OpenSEES 2.3.1
kengawk wrote:
> yeah, I am reading this part too.
> from warning, the value in setResponse is zero, and the program exit when
> sourcing.
hi,
where did you find the command? I didn't see any in opensees wiki online. thx.
> yeah, I am reading this part too.
> from warning, the value in setResponse is zero, and the program exit when
> sourcing.
hi,
where did you find the command? I didn't see any in opensees wiki online. thx.