UNIT OPENSEES

Forum for OpenSees users to post questions, comments, etc. on the use of the OpenSees interpreter, OpenSees.exe

Moderators: silvia, selimgunay, Moderators

Post Reply
suciputrielza
Posts: 11
Joined: Sun Apr 08, 2012 5:17 am
Location: andalas university

UNIT OPENSEES

Post by suciputrielza »

What a unit that is used in opensees navigator ...
whether the assumptions themselves or any of its provisions?? ..
whether to use international units ...
example
for the length if we have to use inches feet or meters?
thank you: D
vesna
Posts: 3033
Joined: Tue May 23, 2006 11:23 am
Location: UC Berkeley

Re: UNIT OPENSEES

Post by vesna »

OpenSees is unit-less. Chose a set of basic units (e.g., m, kN, sec) and use it consistently throughout your code.
shivanirani11
Posts: 82
Joined: Tue Jun 19, 2012 1:56 am

Re: UNIT OPENSEES

Post by shivanirani11 »

But the basic unit in opensees are inch, sec, kip. Then how can we choose a different set of the units until we change the current unit into them
vesna
Posts: 3033
Joined: Tue May 23, 2006 11:23 am
Location: UC Berkeley

Re: UNIT OPENSEES

Post by vesna »

OpenSees does not have basic unit system. You just select any set of units and make sure to define all variables in the specified set of units.
suciputrielza
Posts: 11
Joined: Sun Apr 08, 2012 5:17 am
Location: andalas university

Re: UNIT OPENSEES

Post by suciputrielza »

thank u vesna :D
Post Reply