I did pushover analysis for my 3D model.In first few modes I got the results,but in 7th mode I have a problem.(my model is SAC9 with 27 modes).
WARNING:CTestNormDispIncr::test<>-failed to converge.
What is wrong with this model?
Error in pushover analysis!
Moderators: silvia, selimgunay, Moderators
Error in pushover analysis!
Hi dear vesna...
I did pushover analysis for my 3D model.In first few modes I got the results,but in 7th mode I have a problem.(my model is SAC9 with 27 modes).
WARNING:CTestNormDispIncr::test<>-failed to converge.
What is wrong with this model?
I did pushover analysis for my 3D model.In first few modes I got the results,but in 7th mode I have a problem.(my model is SAC9 with 27 modes).
WARNING:CTestNormDispIncr::test<>-failed to converge.
What is wrong with this model?
Re: Error in pushover analysis!
The warning message you got only says that you could not converge to a solution. The reasons can be many. Are you doing analysis in a while loop to prevent convergence problems?