Set Deformed condition to a initial condition.

For posts concerning the documentation, errors, ommissions, general comments, etc.

Moderators: silvia, selimgunay, Moderators

Post Reply
sshobit
Posts: 1
Joined: Tue Jun 21, 2016 10:36 pm
Location: IIT Kanpur

Set Deformed condition to a initial condition.

Post by sshobit »

Hi all,
I have performed a pushover over analysis and obtained my results. Now I want to perform a dynamic analysis on a deformed structure as a result of pushover analysis.
Is this is possible to do that in Opensees ? if yes then how ??
Please help me guys, A BIG Thanks in advance
Top
fmk
Site Admin
Posts: 5884
Joined: Fri Jun 11, 2004 2:33 pm
Location: UC Berkeley
Contact:
Contact fmk

Re: Set Deformed condition to a initial condition.

Post by fmk »

yes .. just start a dynamic analysis (reset time to 0.0 unless you add a lot of 0's to timeseries) and probably set the loads that got you there constant, i.e. loadConst -time 0.0
Top
maryanam
Posts: 1
Joined: Wed Jan 09, 2019 12:49 am
Contact:
Contact maryanam

Re: Set Deformed condition to a initial condition.

Post by maryanam »

yes
Top
Post Reply

Return to “Documentation”