Question about a model using Hysteretic Material

[polarisiqi]

hi,all
I modeled a joint using hysterical material(uniaxialMaterial Hysteretic $matTag $s1p $e1p $s2p $e2p <$s3p $e3p> $s1n $e1n $s2n $e2n <$s3n $e3n> $pinchX $pinchY $damage1 $damage2 <$beta>) and get a question:
I use the different $s1p $e1p $s2p $e2p $s1n $e1n $s2n $e2n but get the same result, this is very strange but I don't find where i am wrong.
Have good day!

[fmk]

you are using the Steel01 material in your section definition and not the Hysteretic material. if you switch you will get different answers.